Wednesday, November 12, 2008
Removing the Inner Support
Removing the inner nose skin was fast and easy. It is spot welded to the upper flange of the inner support. Since my inner support is coming out, it was OK to drill all the way through the spot welds. I just zipped the bottom edge off, leaving it attached to the support piece. Removing the inner support is a little more delicate since it is spot welded along its upper edge to something that I plan to keep. You can drill out the spots from below pretty easily if you cut to bottom flange off of the inner support. The tabs that connect the inner support to the frame head are going to be tricky to remove due to limited access - I'm going to leave them alone until I see what the new support piece has on it.
Subscribe to:
Post Comments (Atom)
2 comments:
It appears you are making excellent progress....it must be a Boyer Project as I notice the Wonder Bar is one of your primary tools :-)
Is there any problem obtaining new replacement panels?
No problem actually - there are a couple of place in CO that make very good quality stuff.
Post a Comment